推薦新聞
滿足標準GB/T22261-2009要求...
填料對硅酮石材耐候聚氨酯密封膠耐污染性的...
測試既有MS密封膠再粘結型試片拉伸粘結性...
不同養護時間對丁基防水嵌縫膠拉伸粘結性的...
不同寬口厚尺寸對聚氨酯密封膠拉伸粘結性的影響
- 發布時間 : 2025-6-6 22:39:17
- Views:
(Summary description)Customized SILICONE STRUCTURAL SEALANT from China manufacturer refers to the adhesive with high strength, can bear large load, aging resistance, fatigue resistance and corrosion resistance, and has stable performance within the expected life. It is suitable for bearing the bonding of strong structural parts. Non structural adhesive has low strength and poor durability. It can only be used for bonding, sealing and fixing of ordinary and temporary properties, and cannot be used for structural adhesive bonding. NEUTRAL SILICONE WETHERPROOF SEALANT from China manufacturer is a structural adhesive with waterproof function. Silicone glue refers to the adhesive based on silicone rubber. According to different functions, it can be divided into structural adhesive, potting adhesive, sealant, thermal conductive adhesive, flame retardant adhesive and so on.
不同寬口厚尺寸對聚氨酯密封膠拉伸粘結性的影響
(Summary description)Customized SILICONE STRUCTURAL SEALANT from China manufacturer refers to the adhesive with high strength, can bear large load, aging resistance, fatigue resistance and corrosion resistance, and has stable performance within the expected life. It is suitable for bearing the bonding of strong structural parts. Non structural adhesive has low strength and poor durability. It can only be used for bonding, sealing and fixing of ordinary and temporary properties, and cannot be used for structural adhesive bonding. NEUTRAL SILICONE WETHERPROOF SEALANT from China manufacturer is a structural adhesive with waterproof function. Silicone glue refers to the adhesive based on silicone rubber. According to different functions, it can be divided into structural adhesive, potting adhesive, sealant, thermal conductive adhesive, flame retardant adhesive and so on.
- 發布時間 : 2025-6-6 22:39:17
- Views:
再粘結試片制備方法如下:切取既有的聚氨酯密封膠,用刀具將其切割成表4中6LJ06B號所述寬厚尺寸,長為a8的試樣,用聚氨酯密封膠(最大強度口重新粘結制得型片,聚氨酯密封膠再粘結層總厚度小于G4必要時可采用底涂增強粘結面的粘結性能,如圖G所示。建筑用聚氨酯密封膠中規定,在標準試驗條件溫度(BMB,相對濕度下養護B(拉伸粘結性實驗采用萬能拉力試驗機進行測試。結果與討論不同寬口厚尺寸對聚氨酯密封膠拉伸粘結性的影響;寬度尺寸變化對聚氨酯密封膠性能的影響取養護P的試片,將同尺寸同條件下的試片測試結果取平均值,處理結果如表M圖BflM所示。
從圖B和圖M可以看出,與其他M組相比,P組試片寬度和厚度尺寸較大,最大強度及最大強度伸長率明顯偏小,這說明該寬度和厚度是不合適的,也不符合聚氨酯密封膠膠縫設計要求口在CM組中,厚度不變時,聚氨酯密封膠試片最大強度隨寬度變化有一些變化,但變化不明顯,其中a組極差最大,為但厚度不變時,聚氨酯密封膠試片最大強度伸長率隨寬度變化較大,其中a組極差最大。厚度尺寸變化對聚氨酯密封膠性能的影響取養護%的試片,將同尺寸同條件下的試片測試結果取平均值,處理結果如表翎圖。http://www.www.sunsage.net/
Scan the QR code to read on your phone
